Page 250 - 凯能全英文KleinTools Catalog 167

Pliers

Strippers, Cutters, and Crimpers

Drivers and Wrenches CLAMP METERS

Conduit Tools and Measurement

Tool Kits

Safety, PPE and Comfort

WARNINGS:
W
ARNINGS:
o
T To ensure safe operation and service of the tester, follow these instructions. Failure to observe these warnings can result in severe injury or death.y or death.
, follow these instructions. Failure to obser
ensure safe operation and ser
vice of the tester
ve these warnings can result in
severe injur
• • Before each use, verify meter operation by measuring a known voltage or current. Before each use, verify meter operation by measuring a known voltage or current. . • • Never assume neutral or ground wires are de-energized. Neutrals in multi-wire branch circuits may be
Never assume neutral or ground wires are de-energized. Neutrals in multi-wire branch cir
cuits may be
energized when disconnected and must be retested before handling.
energized when disconnected and must be retested before handling.
y based rating of this meter
• • Never use the meter on a circuit with voltages that exceed the category based rating of this meter.
Never use the meter on a cir
cuit with voltages that exceed the categor
Jobsite Accessories • • Do not use the meter during electrical storms or in wet weather. . • • Use caution when working with voltages above 60V DC, or 25V AC RMS. Such voltages pose a shock hazard.
Use caution when working with voltages above 60V DC, or 25V AC RMS. Such voltages pose a shock hazard.
Do not use the meter during electrical storms or in wet weather
• • To avoid false readings that can lead to electrical shock, replace batteries if a low battery indicator appears.y indicator appears.
T
o
avoid false readings that can lead to electrical shock, replace batteries if a low batter
• • Do not use the meter or test leads if they appear to be damaged.Do not use the meter or test leads if they appear to be damaged.
• • Ensure meter leads are fully seated, and keep fingers away from the Ensure meter leads are fully seated, and keep fingers away from the
• • Always adhere to local and national safety codes. Use individual protective equipment Always adhere to local and national safety codes. Use individual protective equipment
metal probe contacts when making measurements. • • Unless measuring voltage or current, shut off and lock out power before measuring resistance or capacitance.Unless measuring voltage or current, shut off and lock out power before measuring resistance or capacitance.
metal probe contacts when making measurements.
to prevent shock and ar
c blast injur
• • Do not open the meter to replace batteries while the probes are connected.Do not open the meter to replace batteries while the probes are connected. to prevent shock and arc blast injury where hazardous live conductors are exposed.y where hazardous live conductors are exposed.
Tool Storage
Voice/Data/Video
Test and Measurement MULTIMETERS
Power Tools and Accessories

Lifting, Pulling, and Structural